It measures systolic and diastolic blood pressure and pulse rate.

Yes, it supports two user profiles (User 1 & User 2) with separate memory storage.

Up to 120 readings per user.

It operates on 4 AAA batteries or a DC adapter (optional).

Sit comfortably, rest your arm on a table, and ensure the cuff is at heart level.

No. Wait 30 minutes after eating, smoking, or exercising for accurate results.

It shows your blood pressure level based on World Health Organization guidelines (Green = Normal, Yellow = Elevated, Red = High).

Yes, it detects irregular heartbeats (IHB) and displays a symbol if found.

To enter the date and time settings:

1. Press and hold the START button, then while holding it,
2. Press and hold the MEM button at the same time.
3. After about 3 seconds, the screen will display the date and time settings. Use the buttons to adjust the values as needed.

Your LOOKEE A2 can display pressure readings in either kPa or mmHg. To switch the unit to mmHg (the standard unit for blood pressure):

1. Press and hold the START button, then press and hold the MEM button at the same time for about 3 seconds to enter the settings menu.
2. Navigate through the settings until you find the unit option.
3. Select mmHg as your preferred measurement unit.
4. Confirm and exit the settings.

Your future readings will now be displayed in mmHg instead of kPa.

MWI (Measurement While Inflation) is an advanced technology that measures your blood pressure while the cuff is inflating, rather than after. This provides several benefits:

• Faster and more comfortable readings — the cuff doesn’t need to inflate as high as traditional monitors.
• Less pressure on your arm, reducing discomfort.
• Accurate results for both systolic and diastolic pressure during a smoother measurement process.

You’ll notice that the device starts displaying your readings sooner, and the cuff will deflate more quickly once the measurement is complete.

The LOOKEE A2 supports two user profiles — User 1 and User 2 — to store readings separately. To switch users:

1. Make sure the device is turned off.
2. Press the MEM button once — the screen will light up showing User 1 or User 2.
3. Press the MEM button again to toggle between users.
4. Wait a few seconds, and the selected user will be saved automatically.

Each user can store up to 120 readings independently.

Cause: The cuff may not be wrapped correctly, or there was movement during the measurement.

Solution: Rewrap the cuff snugly around your upper arm and remain still while the test is in progress. Then, try again.

If you continue to receive an error message, please contact LOOKEE Support at support@LookeeTech.com

Cause: The batteries may not be inserted properly.

Solution: Check the battery orientation and ensure they are correctly placed. Replace the batteries if needed.

Cause: Readings can vary due to movement, stress, or talking during measurement.

Solution: Rest quietly for at least 5 minutes before retesting to ensure an accurate reading.

Cause: The battery power may be too low.

Solution: Replace the batteries with new ones or connect the DC adapter if available.